–
| Remove oil pressure switch -F1- → Item»green insulation« and screw into tester. |
–
| Screw tester into cylinder head in place of oil pressure switch. |
–
| Connect brown wire of tester to earth (-). |
–
| Connect voltage tester -V.A.G 1527 B- using auxiliary cables from -V.A.G 1594 A- to battery positive (+) and oil pressure switch. LED should not light up. |
–
| Start engine and increase revolutions slowly. At 0.3 ... 0.6 bar, the LED must light up; otherwise renew oil pressure switch. |
|
|
|