seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Pressure differential senderG505: Removing and installing. > < Tightening exhaust temperature sender 4G648

Leon Mk2

Tightening exhaust temperature sender 3G495
Tightening exhaust temperature sender 3 -G495-
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Adjustment tool -T100395-, see equivalent → Anchor
  W00-10767
t  Torque wrench -VAG 1331-, see equivalent → Anchor.
  W00-0427
Installation position of the temperature sender exhaust gas temperature sender 3 -G495-:
l  Angled section of pipe faces towards left side of vehicle.
l  Angle -α- with regard to marking -arrow- = approx. 17°.
  WARNING
The torque wrench -V.A.G 1331- must be set to 29 Nm in this case.
Extending the torque wrench -V.A.G 1331- with the spanner from tool set -T10395/6- allows the correct torque of 45 Nm to be achieved.
Lubricate thread of sender using high-temperature paste -G 052 112 A3-.
  A26-10729
–  Screw exhaust temperature sender 3 -G495- in by hand.
–  Then apply tightening torque using torque wrench -V.A.G 1331- together with wrench from tool set -T10395/6-.
  N26-10523

Pressure differential senderG505: Removing and installing. > < Tightening exhaust temperature sender 4G648