SEAT Workshop Service and Repair Manuals

Checking distribution timing t  Test sequence → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Camshaft clamp -T10123-

t  Fastening bolt -T10121- Test sequence –  Remove air filter → Chapter.

–  Remove the camshaft housing cover -arrows-.

–  Remove the engine speed sender -G28- → Chapter.

–  Turn the crankshaft with the securing bolt of the pulley in engine rotation direction until the grooves on both camshafts are horizontal.

–  The camshaft fasteners -T10123- must enter the camshafts easily. –  Fit both tools tightening the hexagonal bolts by hand -M6-.

–  Now lock the crankshaft by inserting the fastening bolt -T10121- in the flywheel drill hole.   Note If it is not possible to insert the fastening bolt -T10121- remove the camshaft fastening pins -T10123- from the camshafts. Turn the crankshaft in the direction of engine rotation (360º) and repeat the operation. If it is not possible to insert both locking tools: –  Adjust valve timing → Chapter. If it is possible to insert both locking tools: –  Remove the locking tools from their housing in the drill holes and remount the sensor and cover. –  Install air filter → Chapter.

–  Fit the camshaft housing cover -arrows-.