Leon Mk2
| Cylinder head - Assembly overview: Engine code letters AZQ, BME and BXV. |
| 1 - | Camshaft housing |
| q | The seal surface should not be reworked |
| q | With integrated camshaft bearings |
| q | Camshaft housing: separating and fitting → Chapter |
| q | Remove all remains of sealant with a standard seal remover or a flat scraper |
| q | Before fitting, apply sealant paste → Parts catalogue |
| q | To fit, place vertically with the adjustment bolts in the cylinder head holes |
| 2 - | Cylinder head bolt |
| q | replace |
| q | Follow installation instructions and sequence when loosening and tightening → Chapter |
| 3 - | Hall sender -G40- |
| q | check → Chapter |
| 4 - | 10 Nm |
| 5 - | O ring |
| q | Replace if damaged |
| 6 - | 10 Nm |
| q |
| 7 - | Support |
| q | For the cable harness |
| 8 - | Oil pressure switch -F1-, 0.3 ... 0.7 bar, 25 Nm |
| q | check → Chapter |
| 9 - | Cylinder head gasket |
| q | Metal gasket |
| q | replace |
| q | Renew coolant after replacing cylinder head gasket |
| 10 - | Guide pin |
| q | Tightening torque: 20 Nm |
| 11 - | 10 Nm |
| 12 - | Lifting eyes |
