Leon Mk2
| Part II |
| 1 - | 90 Nm + 1/4 turn (90°) further |
| q | Renew |
| q | Counter-hold with -T20018- to loosen and tighten |
| q | Threads and shoulder must be free of oil and grease |
| q | The quarter turn further can be done in several stages |
| 2 - | 40 Nm + 1/4 turn (90°) further |
| q | Renew |
| 3 - | 15 Nm |
| 4 - | 22 Nm |
| 5 - | Toothed belt guard - lower part |
| 6 - | 10 Nm |
| 7 - | Toothed belt guard - centre part |
| 8 - | Upper guard for toothed belt |
| 9 - | Toothed belt |
| q | Mark D.O.R. before removing |
| q | Check for wear |
| q | Do not kink |
| q | Removing, installing and tensioning → Chapter |
| 10 - | Idler wheel |
| 11 - | 20 Nm + 1/4 turn (90°) further |
| q | Renewing |
| 12 - | 20 Nm |
| 13 - | 20 Nm |
| 14 - | 40 Nm |
| 15 - | Camshaft sprocket |
| q | Drive off camshaft taper using ham-mer and drift through toothed belt guard openings |
| 16 - | Tensioning roller |
| q | Checking semi-automatic toothed belt tensioning roller → Chapter |
| 17 - | Idler wheel |
| 18 - | Injection pump sprocket |
| q | Two part |
| 19 - | 30 Nm |
| 20 - | Rear toothed belt guard |
| 21 - | Coolant pump |
| q | Removing and installing → Chapter |
| 22 - | Idler wheel |
| q | Remove to remove coolant pump |
| q | Removing and installing → Chapter; Removing and installing coolant pump |
| 23 - | Crankshaft toothed belt sprocket |
| 24 - | Bush |
| 25 - | Injection pump |
| q | Removing and installing → Chapter |
| 26 - | Complete support |
| q | For injection pump, alternator and vane pump for power assisted steering |
| q | For vehicles without air conditioner |
| q | Removing and installing compact bracket on vehicles with air conditioner → Heater, air conditioner; Rep. Gr.87 |
| 27 - | 45 Nm |
