Leon Mk2
| Fuel tank and accessory pieces: removal and refitting |
| 1 - | Stopper |
| 2 - | Seal |
| q | Replace if worn |
| 3 - | Tank stopper unit |
| q | Removal and refitting → Bodywork, assembly work; Rep. Gr.55 |
| 4 - | Breather pipe |
| 5 - | Gravitatory/overload valve |
| q | To remove, release the safety lip and lift the valve from the loading mouth |
| q | Check the passage continuity of the valve |
| Perpendicular valve: open |
| Valve inclined 90° closed |
| 6 - | O ring |
| q | Replace if worn |
| 7 - | Ground connection |
| 8 - | 4 Nm |
| 9 - | Loading mouth |
| q | With non return valve |
| 10 - | Dustcover |
| q | After fitting the loading mouth, fix above the mouth of the fuel tank |
| 11 - | Fuel tank |
| q | Removing and refitting → Chapter |
| 12 - | Antithermal plate |
| q | Welded to the fuel tank |
| 13 - | 25 Nm |
| 14 - | Support clip |
| q | Welded to the fuel tank |
| 15 - | Transmitter for the fuel level |
| q | Note the assembly position of the fuel tank → Fig. |
| q | Transmitter with sieve that can be moved with respect to the upper element |
| 16 - | Seal ring |
| q | Replace in the event of fault |
| q | Dampen with fuel when fitting |
| 17 - | Flange |
| q | Note the assembly position of the fuel tank → Fig. |
| 18 - | Stopper nut |
| q | Remove and refit with -U-40055A- |
| 19 - | Return pipe |
| q | Blue or blue mark |
| q | Make sure the seat is firm |
| q | From the fuel filter → Item |
| q | Embedded in the fuel tank |
| 20 - | Supply pipe |
| q | Black |
| q | Make sure the seat is firm |
| q | To the fuel filter → Item |
| q | Embedded in the fuel tank |
| 21 - | Connector |
| q | Black, 2 contacts |
| 22 - | Breather valve |
| q | To dismantle, press the fixing lip slightly inwards -arrow- and extract the valve |
| q | Checking → Fig. |
| 23 - | Dustcover |
| q | For loading mouth |
| 24 - | Fixing ring |
Note!
|
|
