SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-cyl. injection engine. (1.6ltrs., 2 valves) | Enginecrankshaft group, pistons | Block, sealing flanges and engine flywheel

Engine flywheel removing and installing

Special tools and workshop equipment required

t	Torque spanners -SAT 8010-

t	Holding tool -T20075A-

Removing

–	Mark installation position of engine flywheel on crankshaft with a permanent marker.

–	Secure counter-hold -T20075A- to cylinder head hole and immobilise the flywheel.

–	Loosen engine flywheel securing bolts and remove the flywheel.

Fitting

–	Place flywheel on crankshaft in the previously marked position.

–	Tighten new flywheel securing bolts.

Tightening torque 60 Nm + ¹/₄ turn (90°).

SEAT Workshop Service and Repair Manuals