| –
| Use the pushing device -T20081B/1- and press down the guide coupling-holder unit until the holder is right at the top. To do so, use the old attachment bolt for the vibration shock-absorber. |
| –
| Remove the guide coupling -T20081B/2-. |
| –
| Install crankshaft toothed belt sprocket. Hold with counter-hold -T20018A- and using a new securing bolt tighten to 90 Nm + 1/4 turn (90°) |
Note! | The turning further angle can be measured with protractor -T20030-. |
| When installing toothed belt and adjusting timing → Chapter. |
|
|
|
