Leon Mk2
| Part I |
| 1 - | Toothed belt upper guard |
| 2 - | Toothed belt |
| q | Before removal, mark the direction of rotation |
| q | Check the wear |
| q | Do not fold |
| q | Remove and install, tighten → Chapter |
| 3 - | 20 Nm + 1/4 turn (90°) |
| q | Renew |
| 4 - | Camshaft pinion |
| q | Check the position when installing the toothed belt → Chapter |
| 5 - | 10 Nm |
| q | Place with D6 |
| 6 - | Rear toothed belt guard |
| 7 - | 10 Nm |
| 8 - | O-ring |
| q | Renew |
| 9 - | Coolant pump |
| 10 - | 20 Nm |
| 11 - | Tensioning roller |
| q | Check → Chapter |
| q | Tighten the toothed belt → Chapter |
| 12 - | 20 Nm |
| 13 - | Toothed belt-crankshaft pinion |
| q | Check the position when installing the toothed belt → Chapter |
| 14 - | Pulley |
| q | Check the mount during installation |
| 15 - | 20 Nm |
| 16 - | Poly-V belt |
| q | Before removal, mark the direction of rotation |
| q | Removing and installing → Chapter |
| 17 - | Hexagon bolt: 90 Nm + 1/3 turn (120°) |
| 12-sided bolt: 90 Nm + 1/4 turn (90°) |
| q | Renew |
| q | Fit lubricated |
| q | The retightening can be carried out in several stages |
| q | The retightening angle can be measured with -T20030- |
| 18 - | Toothed belt lower guard |
