| Removing and installing parts of cooling system |
Note! | t
| When the engine is warm the cooling system is under pressure. If necessary release pressure before commencing repair work. |
| t
| Hoses are secured with spring-type clips. In cases of repair only use spring-type clips. |
| t
| It is recommended that pliers -T20029- are used to remove and install spring-type clamps. |
| Perform cooling system leakage test with cooling system tester -V.A.G 1274- and adapters -V.A.G 1274/8- and -V.A.G 1274/9-. |
| Parts of cooling system engine side → Chapter. |
| Coolant mixture ratios → Chapter, draining and filling with coolant |
|
|
|
