Leon Mk2
Removing and installing parts of the ignition system |
Note!
Motronic control unit -J220-* with connectors → Item. |
1 - | Connector |
q | Black, 4 pin |
q | For ignition transformer -N152- |
2 - | Ignition transformer -N152-* |
q | Fitting location → Chapter, engine compartment overview |
q | Checking → Chapter |
q | With marking for ignition cables: A = Cylinder 1 B = Cylinder 3 C = Cylinder 2 D = Cylinder 4 |
3 - | 10 Nm |
4 - | Connector |
q | Black, 2-pin |
q | For knock sensor 1 -G61- |
q | Sensor and connector contacts are goldplated |
5 - | Knock sensor 1 -G61-* |
q | Fitting location → Chapter, engine compartment overview |
q | Checking → Chapter |
q | Sensor and connector contacts are goldplated |
6 - | 20 Nm |
q | Tightening torque influences the function of the knock sensor |
7 - | Connector |
q | Black, 3-pin |
q | Hall sender -G40- |
8 - | Hall sender -G40-* |
q | Fitting location → Chapter, engine compartment overview |
q | Checking → Chapter |
9 - | O ring |
q | Renew if damaged |
10 - | Spark plug, 30 Nm |
q | Remove and install with spark plug spanner -3122B- |
q | Type and electrode gap → Chapter, test data, spark plugs |
11 - | Bracket |
q | For ignition transformer -N152- |
12 - | H.T. cable |
q | With suppression connector and spark plug connector |
q | Resistance 4.8...7.2 kΩ |