Leon Mk2
| Components overview |
| 1 - | Knock sensor I -G61- |
| q | Checking: → Chapter |
| 2 - | 20 Nm |
| q | Tightening torque affects the knock sensor function |
| 3 - | Knock sensor II -G66- |
| 4 - | Oil dipstick |
| q | Oil level must not be above max. mark on dipstick! |
| 5 - | Filling funnel |
| 6 - | O-ring |
| q | Replace |
| 7 - | Coolant pipe |
| 8 - | 20 Nm |
| 9 - | Oil filter bracket |
| q | Dismantling and assembling: → Chapter |
| 10 - | 15 Nm + retighten 1/4 turn (90º) |
| q | Replace |
| 11 - | Oil cooler |
| q | Grease → Parts Catalogue the contact surfaces with the oil filter mounting, outside the ring seal |
| q | Check that there is sufficient clearance with the adjacent parts |
| q | See note → Chapter |
| 12 - | 25 Nm |
| 13 - | Oil filter |
| q | Loosen with the rotation tool -U-40078- |
| q | Tighten by hand |
| q | Observe the installation instructions printed on the filter |
| 14 - | Gasket |
| q | Replace |
| 15 - | 10 Nm |
| 16 - | Engine speed sender -G28- |
| q | Checking: → Chapter |
| 17 - | Union sleeve |
| 18 - | 15 Nm |
| 19 - | O-ring |
| q | Replace |
| 20 - | Coolant thermostat |
| q | Checking: heat the thermostat in water |
| q | Approx. commencement of opening 86 °C |
| q | Ending at 102 ºC |
| q | Opening stroke at least 7 mm |
| q | Installing and removing: → Chapter |
| 21 - | 45 Nm |
| 22 - | Bracket for additional units |
| q | For poly-V belt tensioning roller, alternator and air conditioner (heating) compressor |
| q | Removing and fitting: → Chapter |
| 22 - | Console |
