seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure and oil pressure switch checking > < Oil pump removal and installation|Removal

Leon Mk2

Installation
Installation
Test conditions
   
l  One of the polygon cams -arrow- is on the upper part of the crankshaft.
Work sequence
–  Fit new gasket onto guide pins.
–  Coat the four crankshaft polygon cams with oil.
  N17-0081
–  Position the oil pump inner rotor markings -arrow A- coinciding with the position mark -B- on oil pump housing cover.
–  Lightly oil sealing lip of oil pump oil seal.
  N17-0074
–  Place connecting piece -T20081B/2- over the oil pump seal and carefully guide the pump on to the crankshaft polygon cams.
–  Align inner rotor to crankshaft polygon cams by turning slightly if necessary.
–  Then slide oil pump carefully onto guide pins.
–  Fit the oil pump with new bolts and tighten to 12 Nm.
–  Separate guide sleeve -T20081B/2-.
–  Fit suction pipe → Item.
–  Install sump → Chapter.
The rest of the assembly is basically a reverse of the dismantling sequence.
–  Fit the toothed belt sprocket and tensioner roller, the toothed belt, fit, tension → Chapter; Toothed belt: removing, installing and tensioning.
  E17-0007

Oil pressure and oil pressure switch checking > < Oil pump removal and installation|Removal