Leon Mk2
| Exhaust manifold, front exhaust pipe and catalytic converter with attachments |
| 1 - | Warm air collector plate |
| q | Tightening sequence → Fig. |
| 2 - | 10 Nm |
| 3 - | Lambda probe 1 before catalytic converter -G39-, 50 Nm |
| q | Checking → Rep. Gr.24 |
| q | Only grease threads with “G 052 112 A3”. “G 052 112 A3” must not get into the slots on the probe body |
| q | Remove and install with spanner -U-40080- |
| q | Ageing of the Lambda probe, check → Chapter, Catalytic converter: checking |
| 4 - | Exhaust manifold |
| q | With pre-catalytic converter integrated |
| 5 - | Gasket |
| q | Renew |
| 6 - | Lock nut, 25 Nm |
| 7 - | Lambda probe 2 after catalytic converter -G130-, 50 Nm |
| q | Checking → Rep. Gr.24 |
| q | Only grease threads with “G 052 112 A3”. “G 052 112 A3” must not get into the slots on the probe body |
| q | Remove and install with spanner -U-40080- |
| 8 - | To front silencer |
| 9 - | Marking |
| q | Visible from below → Item |
| 10 - | Connector |
| q | For Lambda probe 2 after catalytic converter -G130- and Lambda probe heating -Z29- |
| q | Black, 4-pin |
| 11 - | Front exhaust pipe with catalytic converter |
| q | Check catalytic converter → Chapter |
| q | Check catalytic converter → Chapter |
| 12 - | 25 Nm |
| 13 - | Tunnel bridge |
| q | With support elemnt for front exhaust pipe with catalytic converter |
| q | Renew if damaged |
| 14 - | Lock nut, 40 Nm |
| 15 - | Gasket |
| q | Renew |
| 16 - | 40 Nm |
| 17 - | Washer |
| 18 - | Support |
Note!
