Leon Mk2
| Sealing flange, pulley side: Exploded view of components |
| 1 - | 120 Nm + 1/4 turn (90°) further |
| q | Replace |
| q | Loosen and tighten with retention tool -3415- |
| q | Do not additionally oil or grease the threads and shoulder |
| q | Turning further can be done in several stages. |
| 2 - | Crankshaft gear |
| q | Contact surface between timing belt sprocket and crankshaft must be free of oil. |
| q | Can only be fitted in one position |
| 3 - | Oil seal for crankshaft (pulley end) |
| q | replace → Chapter |
| q | Do not lubricate with oil |
| 4 - | Sealing flange (pulley side) |
| q | Must seat on dowel pins. |
| q | removing and fitting → Chapter |
| 5 - | cylinder block |
| 6 - | Mounting bush |
| q | 2 units |
| 7 - | 15 Nm |
| q | Tighten respecting the tightening order → Fig. |
|
|
|
