SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-cylinder diesel engine (1.6 l 4V, TDI Common-Rail) | Exhaust turbocharger, G-charger | Charge air system with turbocharger | Removing and installing charge pressure senderG31 / intake air temperature senderG42

Removing and installing charge pressure senderG31 / intake air temperature senderG42

Removing and installing charge pressure sender -G31- / intake air temperature sender -G42-

Removal:

–	Remove the soundproofing or the underbody protection → Bodywork, exterior assembly work; Rep. gr.50.

–	Disconnect connector -2-.

–	Remove the bolts -1- and pull charge air pressure sender -G31-/intake air temperature sender -G42- out of air pipe.

Installation

l	Tightening torque: 5 Nm.

Installation is carried out in reverse order, noting the following:

Note

Renew O-ring.

SEAT Workshop Service and Repair Manuals