–
| Fit renewed clips before fitting the injector. To do this, grease lightly. |
Installing new injectors: |
When installing a new injector, the following must be replaced: |
Included in scope of supply |
t
| O-ring for injector shaft |
t
| O-ring for injector return line |
t
| Retaining clip for injector return |
Continuation for used and new injectors: |
–
| Use a plastic socket to mount new copper seal. |
–
| Lubricate all O-rings with engine oil or assembly oil before installing. |
–
| Fit new O-rings for injector shaft. |
–
| Push clamping piece onto injectors, during this process pay attention to installation position. |
–
| Carefully guide two injectors at a time into the injector bores in the cylinder head. |
–
| First tighten bolt only to maximum 2 Nm. |
l
| Injectors must still be able to move. |
Remaining assembly is performed in reverse sequence. |
Note t
| „Reading / adapting“ correction values. |
|
|
|