SEAT Workshop Service and Repair Manuals

Removing and installing engine speed sender -G28- t  Removing → Anchor t  Fitting → Anchor t  Tightening torques → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  AF-4mm wrench -T10370-, see equivalent → Anchor

t  Extractor -T10118-, see equivalent → Anchor t  Torque wrench -VAG 1331-, see equivalent → Anchor. Removing

–  Unscrew the securing bolts -arrows- and remove the engine soundproofing..

–  Unplug the electrical connector -1- using the extractor -G28- from the engine speed sender -T10118-.   Note To release the electrical connection without using the extractor -T10118-, press, using a screwdriver, on the engine speed sender connector and, at the same time, lift the release button using a thin wire hook. –  Remove oil filter bracket → Chapter.

–  Loosen the securing bolt -arrow- and pull the engine speed sender -G28- out. Fitting Installation is carried out in the reverse order of removing, when doing this note the following. –  Fit the oil filter bracket → Chapter. Tightening torques

Component		Nm
Fixing screw for the engine speed sender -G28-		5