seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Assembly overview - front exhaust pipe with particulate filter > < Engine control unitJ623 with locking device: removing and fitting

Leon Mk2

Exhaust system
Exhaust system
  Note
t  After completing work on the exhaust system ensure that it is tension-free and remains at a sufficient distance from the bodywork. If necessary, loosen the clamp and align the silencer and the exhaust pipe so that there is always a sufficient distance from the bodywork and is evenly distributed over the suspension elements.
t  Renew self-locking nuts.
t  In order to prevent the decoupling element splaying too far from the front exhaust pipe, use the transport lock -T10404-.
→ Chapter „Assembly overview - front exhaust pipe with particulate filter“
→ Chapter „Particle filter Removing and installing.“
→ Chapter „Exhaust gas temperature sender 3 -G495-: Removing and installing.“
→ Chapter „Exhaust gas temperature sender 4 -G648-: Removing and installing.“
  Caution
When doing any repair work, especially in the engine compartment, pay attention to the following due to the cramped conditions:
t  Route all the various lines and electrical wiring so that they are in their original positions.
t  e.g. for fuel, hydraulics, activated charcoal filter system, coolant and refrigerant, brake fluid, vacuum.
t  Ensure that there is sufficient clearance to all moving or hot components.
   

Assembly overview - front exhaust pipe with particulate filter > < Engine control unitJ623 with locking device: removing and fitting