Leon Mk2
| Assembly overview - crankshaft |
| 1 - | Bearing shells 1, 2, 4 and 5 |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove |
| q | Do not interchange used bearing shells (mark). |
| 2 - | 65 Nm + 1/4 turn (90°) further |
| q | Renew |
| q | Threaded along complete length. |
| q | To measure radial clearance, tighten to 65 Nm but not further. |
| 3 - | Bearing cap |
| q | Bearing cap 1 - Belt pulley side. |
| q | Bearing cap 3 with recesses for thrust washers. |
| q | Bearing shell retaining lugs in cylinder block and bearing caps must align. |
| 4 - | Bearing shell 3 |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove |
| 5 - | Thrust washer |
| q | For bearing cap, bearing 3. |
| q | Note fixing arrangement. |
| 6 - | Crankshaft |
| q | Axial play, new: 0.07...0.17 mm; wear limit: 0.37 mm |
| q | Check radial clearance using Plastigage, new: 0.03...0.08 mm; wear limit: 0.17 mm |
| q | Do not rotate crankshaft when checking radial clearance. |
| q | Crankshaft dimensions → Chapter. |
| 7 - | Thrust washer |
| q | For cylinder block, bearing 3 |
