Leon Mk2
| Poly V belt for generator, power steering pump and AC compressor |
| 1 - | 25 Nm |
| 2 - | Tensioning element |
| 3 - | Poly-V belt |
| q | Check for wear |
| q | Mark direction of rotation with chalk or felt pen before removing. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | removing and fitting → Chapter |
| q | When mounting, check that it sits correctly in the pulleys. |
| 4 - | 23 Nm |
| 5 - | Bracket for ancillary mechanical units |
| q | removing and fitting → Chapter |
| 6 - | 40 Nm |
| q | Fit with locking fluid; locking fluid → Parts catalogue |
| 7 - | Alternator |
| q | Removing and fitting → Electrical system; Rep. gr.27 |
| 8 - | 23 Nm |
| 9 - | 40 Nm |
| q | Fit with locking fluid; locking fluid → Parts catalogue |
| 10 - | 23 Nm |
| 11 - | Power steering pump |
| q | Removing and installing → Running gear, front-wheel drive and four-wheel drive; Rep. gr.48 |
| 12 - | 40 Nm |
| q | Fit with locking fluid; locking fluid → Parts catalogue |
| 13 - | Air conditioning compressor |
| q | On installation, pay attention to dowel sleeves in bolt holes |
| 14 - | 25 Nm |
| 15 - | Pulley |
| q | Can only be fitted in one position |
| q | removing and fitting → Chapter |
| 16 - | 23 Nm |
| 17 - | Guide roller |
| q | Secured to bracket for ancillaries |
| 18 - | Special screw -25 Nm |
| q | For idler roller |
| q | Replacement → Parts catalogue |
