SEAT Workshop Service and Repair Manuals

Engine brackets: adjustment t  Verifying the adjustment → Anchor t  Adjusting → Anchor t  Specified torques → Anchor. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Suspension tool -10 - 222 A-, see equivalent → Anchor

Verifying the adjustment –  Remove the engine cover upwards -arrows-.

–  Loosen the bolt by one turn -1-. –  Unscrew bolt -2- and nut -3-. –  Leave the fuel filter to one side with the flexible hoses.

The following dimensions must be reached: l  Between the engine support foot and the right longitudinal member there must be a distance of -a- = 13.5 mm. l  The moulded edge at the engine support foot -2- must be parallel to the support arm -1- (dimension-x- = dimension-x-).   Note The dimension -a- = 13.5 mm can be checked, for example, with an appropriate cylinder object. Adjusting If the gap is too narrow or too wide, proceed as follows:

–  Remove the air conduit cover by releasing the side tabs -arrows-.

–  Unclip the air conduit in the lower part by releasing the tabs -arrows-. –  Remove the lower section of the air duct together with the air hose.

–  Remove the electrical connector -1- from the air mass meter -G70-. –  Uncouple the flexible air hose -3- and the flexible air conduit -2-. –  Unscrew the bolt -4- and remove the air filter housing.

–  Disconnect the breather hose -1- and the air conduit hoses -3- and -5-. –  Unscrew bolt -4- and remove air filter housing.

–  Remove battery → Electrical system; Rep. gr.27. –  Remove battery tray -arrows-.

–  Fit the support tool -10 - 222 A- with the necessary adapters and attach as shown in the figure. –  Engage the trigger snaps of the spindles on the lifting eyes. –  Pretension engine with both spindles equally, do not lift.

–  Unscrew the bolts -arrows- of the gearbox/engine mounting

–  -arrows- one after the other. –  Renew all 5 bolts one after another (if they have not already been removed when the engine was installed) and screw them in by hand.

–  Use an iron bar between engine console -1- and support arm -2- to move the engine until the following dimensions are reached: l  Between the engine support foot and the right longitudinal member there must be a distance of -a- = 13.5 mm. l  The moulded edge at the engine support foot -2- must be parallel to the support arm -1- (dimension-x- = dimension-x-).   Note The dimension -a- = 13.5 mm can be checked, for example, with an appropriate cylinder object. –  Tighten the bolts of the engine mountings on the engine side to 60 Nm + 1/4 turn (90°).

–  Note to the sides of the gearbox, the parallelism of the support arm -2- and the gearbox bracket -1- (dimension -x- = dimension -x-). –  Tighten the bolts of the engine mountings on the gearbox side to 60 Nm + 1/4 turn (+90°). Installation is carried out in the reverse order of removing, when doing this note the following. –  Install battery → Electrical system; Rep. gr.27. Specified torques .

Component	Nm
Holding arm to engine support	60 + 90° 1)2)
Holding arm to gearbox support	60 + 90° 1)2)
l  1) Renew bolts l  2) 90° equals a fourth of a turn.