SEAT Workshop Service and Repair Manuals

the lower coolant pipe: Removing and installing t  Removing → Anchor t  Installing → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

Removing –  Disconnect the engine cover-arrow-. –  Drain coolant → Chapter.

–  Remove vent hose from motor for intake pipe flap -V157-, for this purpose loosen clamp -arrow-.

–  Loosen nut -1- and place radiator pump for exhaust gas recirculation -V400- at side with coolant hoses -2- and -3- connected.   Note Item -4- can be disregarded.

–  Unscrew bolt -1- and double bolt -3-. –  Remove upper coolant pipe from hoses, for this purpose loosen the clamps -arrows- and lift retaining clips -2-. Installing Installation is carried out in the reverse sequence; note the following:   Note Secure all hose connections with the correct type of hose clips (same as original equipment) → Spare parts catalogue.

–  Connect coolant hose with plug-in connector to coolant pipe → Fig. –  Fill up coolant → Chapter. Tightening torques

Component		Nm
Coolant pipe	Engine lifting eye	10
Over	Oil filter bracket	10