SEAT Workshop Service and Repair Manuals

Removing and installing electrical radiator fan -V7- and radiator fan -2- -V177- t  Removing → Anchor. t  Installing → Anchor. Removing .

–  Remove the engine cover upwards -arrows-.

–  Remove the air conduit cover by releasing the side tabs -arrows-.

–  Unclip lower air duct -2- by releasing retaining clips on left and right -arrow A-. –  Detach lower air duct at mounting brackets -3-; swing lower air duct backwards slightly for this. –  Detach air pipe -1- from lower air duct -arrow B-.

–  Remove bolts -top arrows- for radiator cowl.   Note t  The bolts -lower arrows- are removed at a later stage. t  Disregard: -Pos. 1-.

–  Fit the centre noise insulation -fasteners 1 ... 3-.

–  Remove air hose; loosen hose clip -2- and raise retaining clip -1- for this.

–  Disconnect connector -1-. –  Remove the bolts -bottom arrows- and take out air cowl downwards.

–  Unplug connector -1-. –  Uncover cables. –  Unscrew nuts -arrows- and remove fan. Installing . l  Specified torque → Chapter. Installation is carried out in the reverse order; note the following: –  Install air hose with plug-in connector → Anchor. –  Fit the centre sound proofing → Exterior body installation work; Rep. gr.50 .