seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Toothed belt drive: component overview > < Removing and installing vibration damper

Leon Mk2

Removing and installing ancillary bracket
Removing and installing ancillary bracket
t  Removing → Anchor.
t  Installing → Anchor.
Removing .
–  Remove engine bracket → Chapter.
–  Remove high-pressure pump → Chapter.
–  Remove the alternator → Electrical system; Rep. gr.27 .
  WARNING
The air conditioner refrigerant circuit must not be opened.
–  Unbolt air conditioner compressor from ancillary bracket and attach it to lock carrier.
   
–  Unbolt idler rollers -1- and -2- and remove bolt of toothed belt guard -arrow-.
  A13-10609
–  Remove bolts -1 ... 6- and detach bracket for ancillaries.
Installing .
Installation is carried out in the reverse order; note the following:
  Note
Renew bolts tightened with specified tightening angle.
–  Check that dowel sleeve at top right between bracket for ancillaries and cylinder block is fitted; insert dowel sleeve if necessary.
–  Tighten the bolts for the ancillary unit bracket → Fig..
–  Install notched belt (adjusting valve timing) → Anchor.
–  Install alternator → Rep. gr.27.
–  Install engine mountings → Chapter.
  A13-10534

Toothed belt drive: component overview > < Removing and installing vibration damper