Leon Mk2
| Sealing flange, pulley side: component overview |
| 1 - | 120 Nm + 90° (1/4 turn) further |
| q | Renew |
| q | Loosen and tighten with retention tool -3415- |
| q | Do not additionally oil or grease the threads and shoulder. |
| q | Turning further can be done in several stages. |
| 2 - | Crankshaft gear |
| q | Contact surface between timing belt sprocket and crankshaft must be free of oil. |
| q | Fitting possible in one position only. |
| 3 - | Oil seal for crankshaft (pulley end) |
| q | Renewing → Chapter. |
| q | Do not use oil |
| 4 - | Sealing flange (pulley side) |
| q | Must seat on dowel pins. |
| q | Removing and installing → Chapter. |
| 5 - | Cylinder block |
| 6 - | Bearing bush |
| q | Qty. 2. |
| 7 - | 15 Nm |
| q | Tighten respecting the tightening order → Fig. |
|
|
|
