seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing vacuum unit for exhaust gas recirculation cooler > < Exhaust gas recirculation system: Assembly overview

Leon Mk2

Removing and installing exhaust gas recirculation cooler
Removing and installing exhaust gas recirculation cooler
t  Removing → Anchor
t  Installing → Anchor
   
Removing
–  Disconnect the engine cover-arrow-.
–  Drain coolant → Chapter.
–  Remove air filter → Chapter.
  E10-10060
–  Pull off vacuum hose -1-.
–  Remove bolts -2-.
–  Unscrew the bolts -4- with the wrench -3320-.
  Note
Ignore position -3-.
  A21-10306
–  Disconnect the coolant hoses -1- and -2-.
–  Remove bolts -arrows- and detach exhaust gas recirculation cooler.
Installing
Installation is carried out in reverse order. The following should be taken into account:
Tightening torques → Chapter
  Note
t  Renew seals and O-rings.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Spare parts catalogue.
–  Fill up with coolant → Chapter.
  A21-10307

Removing and installing vacuum unit for exhaust gas recirculation cooler > < Exhaust gas recirculation system: Assembly overview