seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gas temperature sender 3G495: Removing and installing. > < Exhaust gas temperature regulation: component overview

Leon Mk2

Exhaust gas temperature sender 1G235: Removing and installing.
Exhaust gas temperature sender 1 -G235-: Removing and installing.
t  Removing → Anchor.
t  Installing → Anchor.
   
Removing .
–  Uncouple the electrical connector -3- for the exhaust gas temperature sender 1 -G235- and free the electrical wiring.
  A23-10003
–  Fit the centre noise insulation -fasteners 1 ... 3-.
  A10-1565
–  Unbolt exhaust gas temperature 1 -G235--item 1- from exhaust manifold.
  Note
The -arrows- can be disregarded.
Installing .
l  Specified torque → Chapter.
Installation is carried out in the reverse order; note the following:
  Note
t  Apply hot bolt paste to the thread of the exhaust gas temperature sender → Spare parts catalogue.
t  Fit cable ties in the original positions when installing.
Location of the exhaust gas temperature sender 1 -G235-:
  A21-10155
l  Angled shaft must have a distance -a- = 3 … 5 mm to bolting of turbocharger support.
  N21-10161

Exhaust gas temperature sender 3G495: Removing and installing. > < Exhaust gas temperature regulation: component overview