seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust manifold > < Exhaust gas temperature sender 3G495: Removing and installing.

Leon Mk2

Exhaust gas temperature sender 4G648: Removing and installing.
Exhaust gas temperature sender 4 -G648-: Removing and installing.
t  Removing → Anchor.
t  Installing → Anchor.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Articulated wrench e/c 17 -T20212-, see equivalent → Anchor
  L26-10003
t  Torque wrench (5 - 50 Nm) -V.A.G 1331-, see equivalent → Anchor
  W00-0427
Removing .
–  Uncouple the electrical connector -2- for the exhaust gas temperature sender 4 -G648- and free the electrical wiring.
  Note
Ignore positions -1, 3, 4 and 5-.
  A23-10003
–  Fit the centre noise insulation -fasteners 1 ... 3-.
  A10-1565
–  Unscrew exhaust temperature sensor 4 -G648--1- with flexible-head wrench SW 17 -T20212-.
  Note
Disregard: -Pos. 2-.
Installing .
l  Specified torque → Chapter.
Installation is carried out in the reverse order; note the following:
  Note
t  Apply hot bolt paste to the thread of the temperature sender after the particle filter → Spare parts catalogue.
t  Fit cable ties in the original positions when installing.
  E26-10050

Exhaust manifold > < Exhaust gas temperature sender 3G495: Removing and installing.