seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gases temperature > < Separating centre and rear silencers

Leon Mk2

Exhaust system: install without stress
Exhaust system: install without stress
Procedure
l  The exhaust system must be installed cold.
–  Loosen bolt connections on front clamp.
   
–  Move the exhaust system forwards -arrow- until the tension on the support tie on the secondary silencer is -a- = 15 … 17 mm.
  A26-0733
–  Install the clamp so that the bolt end does not project over the clamp lower edge.
l  Threaded connection faces right
–  Tighten the bolts on the clamp evenly to 25 Nm.
Align the end pipes:
  A26-0277
–  Align the secondary silencer so that there is an equal distance -a- and -b- between the indentation passage in the rear bumper and the end pipes.
–  To centre the end tubes, loosen the secondary silencer suspension, if necessary.
  V26-0959

Exhaust gases temperature > < Separating centre and rear silencers