SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Exhaust turbocharger, G-charger >
< Accelerator pedal module Assembly overview
Leon Mk2
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Fuel supply, gas operation
Accelerator mechanism
Removing and installing accelerator pedal module with accelerator position sender
Removing and installing accelerator pedal module with accelerator position sender
Removing and installing accelerator pedal module with accelerator position sender
Removal:
–
Remove dash panel trim (bottom) on driver's side
→ Rep. gr.68
.
–
Push release tab
-1-
upwards
-arrow-
and unplug electrical connector
-2-
.
–
Remove bolt
-3-
and take out accelerator pedal module downwards.
Installation
l
Tightening torque
→ Chapter
Installation is carried out in the reverse sequence; note the following:
–
Attach accelerator pedal module
-4-
to bottom of pedal bracket
-1-
, insert centring pin
-2-
and tighten bolt
-3-
.
–
Install dash panel trim (bottom) on driver's side
→ Rep. gr.68
.
–
After renewing, perform kick-down adaption in „Guided Functions“ mode
→ Vehicle diagnostic tester
.
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Fuel supply, gas operation
Accelerator mechanism
Removing and installing accelerator pedal module with accelerator position sender
Exhaust turbocharger, G-charger >
< Accelerator pedal module Assembly overview