SEAT Workshop Service and Repair Manuals

Removing and installing coolant pipe t  Removing → Anchor. t  Installing → Anchor. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Tray -VAS 6208-, see equivalent → Anchor

t  Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor Removing   WARNING Hot vapour/hot coolant may escape when opening expansion tank. Cover cap with cloth and open carefully. –  Open cap on coolant expansion tank.

–  Pull off engine cover panel -arrows-.

–  Release quick-fasteners -1- and -2- and take off front noise insulation. –  If fitted, release quick fasteners -3- and remove rear noise insulation. –  Drain coolant → Chapter. –  Remove intake manifold → Chapter.

–  Unscrew the the cable harness mount -arrows- from the water pipes.

–  Remove coolant hose -1-. –  Unscrew the bolt -2-.

–  Detach coolant hoses -arrows- from coolant pipe. –  Unscrew bolt -1- and detach coolant pipe. Installing Reassembly is carried out in the reverse order; note the following:   Note t  Renew gaskets and seals. t  Secure all hose connections with the correct hose clips (same as original equipment) → Parts catalogue. –  Before installing, clean and smoothen sealing surface for O-ring as required. –  Coat the new O-Ring with G12+ and mount on the coolant pipe. –  Installing intake manifold → Chapter. –  Fill up with coolant → Chapter. Tightening torques

Components:			Nm
Coolant hose to engine block			10
Coolant pipe to thermostat housing			10