SEAT Workshop Service and Repair Manuals

Ignition coil with output stage: Removing and installing t  Removing → Anchor. t  Installing → Anchor. Special tools and workshop equipment required

t  Extractor -T40039-, see equivalent → Anchor Removing

–  Unscrew two bolts -1- on connector rail.   Note

t  In order to extract the spark plugs, fit the extractor -T40039- into the upper large groove -arrow- on the ignition coils with final power output stage. t  If the lower grooves are used, damage may occur.

–  Pull out all ignition coils by using the extractor -T40039- for about 30 mm from their allotment.

–  Release connectors and unplug all connectors from the ignition coils at the same time. –  Remove ignition coils. Installing –  Insert all of the ignition coils into the allotment so that there is space.

–  Align the ignition coils with the connectors and insert all the connectors on the ignition coils simultaneously. –  Press ignition coils onto spark plugs by hand with uniform pressure.