seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Radiator: removing and fitting

Leon Mk2

Coolant pump: removing and fitting
Coolant pump: removing and fitting
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
   
Special tools and workshop equipment required
t  Refractometer -T10007-
t  Pliers for spring type clips -VAS 5024A-, see equivalent → Anchor
t  Torque wrench (5 - 50 Nm) -V.A.G 1331-, see equivalent → Anchor

Adjust the coolant pump wrench -V.A.G 1590-
   
–  Due to changes to the securing bolts of the coolant pump pulley, file the rounded ends by a = 1 mm at minimum.
  Note
t  The integrated coolant pump seal must not be separated from the coolant pump.
t  Damaged or leaking coolant pumps must be completely replaced with seal.
Removing
–  Coolant; Draining → Chapter
–  Poly-V belt: removing → Chapter
–  Remove the coolant pump pulley. To lock the pulley, use the coolant pump wrench -V.A.G 1590-.
Fitting
Installation is carried out in the reverse order. When installing, note the following:
–  Place the coolant pump onto the engine block.
–  Tighten securing bolts to 10 Nm
–  Tighten the coolant pump pulley to 20 Nm. To lock the pulley, use the coolant pump wrench -V.A.G 1590-.
–  Poly-V belt: fitting → Chapter
–  Coolant; filling → Chapter.
  N19-0017

Fuel supply, gas operation > < Radiator: removing and fitting