seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Crankshaft dimensions > < E - Check the fitting position of the sender crown on the crankshaft.
F - Re-adjust the sender crown
F - Re-adjust the sender crown
   
–  Secure the assembly device -T10134- using the Allen bolts -A- to the crankshaft flange.
–  Tighten both Allen bolts by hand.
–  Move the fitting device -T10134- by hand onto the sealing flange.
  N13-10044
–  Hand tighten the hexagonal bolt -E- on the threaded spindle until it comes into contact with the installation bell -C-.
  N13-10084
–  Tighten the hexagonal nut of the assembly device -T10134- to a torque of 40 Nm using the torque wrench -V.A.G 1331- and the insertable terminal e/c 24 -V.A.G 1332/11-.
–  Check the fitting position of the sender crown on the crankshaft once more. → Chapter
If distance -A- is still too small:
–  Tighten the hexagonal bolt of the assembly device -T10134- to a torque of 45 Nm.
–  Check the fitting position of the sender wheel on the crankshaft once more → Chapter
  N13-10085

Crankshaft dimensions > < E - Check the fitting position of the sender crown on the crankshaft.