seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing injectors|Fitting > < Removing and installing injectors

Leon Mk2

Removal:
Removal:
–  Open the fuse and relay holder cover of electrical module in engine compartment.
–  Remove the fuel pump fuse from instrument panel fuse holder. Fuse installation → Current flow diagrams, Electrical fault finding and Fitting locations
  Note
When removing the fuse, cut the power supply to the fuel pump for safety reasons. Otherwise, the fuel pump will start functioning when the driver's door is opened.
  WARNING
Fuel supply pipes are pressurised. Wear safety goggles and appropriate clothing to avoid injury and contact with skin. Before loosening hose connections, wrap a cloth around the connection. Then eliminate the pressure by carefully separating the pipe.
   
–  Disconnect fuel pipe -2-, and collect leaking fuel with a cloth.
  Note
Press in safety ring to release fuel lines.
–  Cover the disconnected fuel lines immediately to avoid the penetration of dirt into the fuel system.
  A20-1065
–  Pull off connectors -arrows- from all the injectors.
–  Unclip the cable harness from the injectors.
–  Remove the fuel rail from the intake manifold.
–  Remove the fuel rail together with the injectors from the intake manifold.
  N15-10082
–  Remove clamp -arrow - and remove the injector.
  A24-0334

Removing and installing injectors|Fitting > < Removing and installing injectors