seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Distribution housing: removing and fitting|Fitting > < Distribution housing: removing and fitting

Leon Mk2

Removing
Removing
–  Remove noise insulation.
–  Remove front right wheel housing liner → General body repairs, exterior; Rep. gr.66.
–  Mark the direction of rotation of the poly V-belt and remove belt → Chapter.
–  Turn crankshaft in direction of engine rotation to TDC No. 1 cylinder → Chapter.
–  Remove coolant pump.
–  Remove banjo bolt from oil supply pipe to turbocharger.
–  Remove air conditioner compressor from bracket with refrigerant lines still connected → Heating, air conditioning; Rep. gr.87.
–  Remove bracket for tensioning element and air conditioner compressor.
–  Detach alternator.
   
–  Install support device -U-30025F- with adapter -U-30025/5B- as shown and hook into lifting eye.
  E13-10085
–  Take up weight of engine and remove securing bolts -arrows-.
–  Remove sump → Chapter.
  N10-0443
–  Now remove pulley securing bolt. Hold pulley with counterhold -3415- and -3415/1-.
  N13-0469
–  Remove Allen head bolts for timing housing and hexagon bolts indicated by -arrows-.
–  Remove valve timing housing.
  Note
Note that crankshaft bearing bush remains in sealing flange.
  N13-10227

Distribution housing: removing and fitting|Fitting > < Distribution housing: removing and fitting