SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-Cylinder injection engine (1.4 l engine with direct injection engine, turbocharger and displacement compressor) | Exhaust system | Removing and installing parts of exhaust system | Installation position and specified torque of the clamp

Installation position and specified torque of the clamp

Note

Gradual introduction of clamp with continuous clip.

Specified torque and mounting dimensions of clamping sleeve.

Clamp -A- with 2 individual clips.

Tightening torque 25 Nm

Installation dimensions -a- 5 mm (only for front clamp)

Clamp -B- with continuous clip.

Tightening torque: 35 Nm

Installation dimensions -a- 8.5 mm (only for front clamp)

Installation dimension -a- for vehicles with marking -A- on front exhaust pipe

1 -

Clamp

2 -	Primary exhaust pipe

3 -	Securing nut

4 -	Securing nut

a -	Installation dimension

A -

Marking

Installation position of front clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces right

Installation position of rear clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces to rear.

SEAT Workshop Service and Repair Manuals