Caution | The screw-type clips on the charge air pipes must be tightened to 5.5 Nm. If the torque is too low or too high, the charge air hose may slip off the charge air pipe during vehicle operation. |
|
Note | t
| Spring-type clip pliers -VAS 5024A- or hose clip pliers -VAS 6340- are recommended for installation of spring-type clips. |
| t
| Secure all hose connections with the correct type of hose clips (same as original equipment). |
| t
| Hose connections and hoses for charge air system must be free of oil and grease before assembly. The oil seal and sealing surface must only be oiled lightly for connector couplings → Chapter. |
| t
| Charge air system must be free of leaks. |
| Assembly overview - charge air system → Chapter |
Note | Fitting hose connections with plug-in connectors → Chapter |
| Checking charge air system for leaks → Chapter |
|
|
|
