SEAT Workshop Service and Repair Manuals

Exhaust manifold: stripping and fitting t  Stripping → Anchor t  Fitting → Anchor t  Torque values → Anchor Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-, see equivalent → Anchor

t  Pliers -SAT 1105-, see equivalent → Anchor Stripping –  Strip the upper part of the inlet manifold → Chapter.

–  Unscrew the fastening bolts -arrows- and remove the engine noise damping cover.

–  Unscrew the right-hand noise damping -fastening points 1 ... 3-.

–  Unscrew the bolts -1- on the exhaust manifold mounting -2- and remove it. –  Lower the vehicle. –  Disconnect electrical connection of the lambda probe -G39-. –  Remove the hot air deflection cover

–  Unscrew the nuts -2- securing the front exhaust pipe to the manifold. –  Unscrew the four upper bolts -1- and the four lower bolts securing the manifold to the cylinder head. –  Take off the exhaust manifold. Fitting   Note t  To prevent exhaust fumes from escaping, clean all connecting surfaces between the manifold, exhaust pipe and cylinder head properly. t  Replace all the gaskets. Continue fitting, following the reverse order of the stripping process. Torque values

Component		Nm
Bolts connecting the manifold to the cylinder head		25 → Note
Bolts connecting the manifold to the front exhaust pipe		40

1)  Apply -G 052 112 A3- to fit bolts while hot