Leon Mk2
| Intake manifold - Components overview |
| 1 - | 8 Nm |
| 2 - | Throttle valve module -J338- |
| q | Clean → Chapter |
| q | When replacing, erase adaptive values and adapt the engine control unit to the throttle control unit → Vehicle diagnosis, testing and information system VAS 5051“Guided function” |
| q | 6-pin connector |
| q | Gold plated contacts |
| 3 - | Oil seal |
| q | Replace if worn |
| 4 - | Vacuum hose |
| q | From the intake hose |
| 5 - | Upper part of intake manifold |
| q | Removing and installing → Chapter |
| 6 - | 8 Nm |
| q | To secure the upper part of the inlet manifold. |
| 7 - | Vacuum hose |
| q | To the fuel pressure control |
| 8 - | To the lower part of the intake manifold |
| 9 - | From the Solenoid valve 1 for active carbon filter (pulsed) -N80- |
| q | Active carbon filter system → Item |
| 10 - | Intake manifold pressure sender -G71- |
| 11 - | Connector |
| 12 - | 4 Nm |
| 13 - | Rubber hose |
| 14 - | Hot air collection plate with intake manifold support |
| 15 - | To the brake servo |
