Leon Mk2
| Toothed belt mechanism - Assembly overview |
| 1 - | Upper protection element for the notched belt |
| 2 - | 100 Nm |
| 3 - | 25 Nm |
| 4 - | Camshaft wheels |
| 5 - | Hub |
| q | With generator wheel |
| q | Use retention tool -T10051- to loosen and tighten |
| q | To remove, use extractor -T10052- |
| q | Removing and fitting → Chapter |
| 6 - | 10 Nm |
| q | Replace. |
| 7 - | Rear notched belt guard |
| 8 - | 25 Nm |
| 9 - | Sealing element |
| q | Replace if damaged |
| 10 - | 20 Nm +45° (1/8 turn) |
| q | To avoid significant damage to the engine apply correct tightening torques |
| 11 - | Tensioning roller |
| 12 - | 20 Nm |
| 13 - | Idler wheel |
| 14 - | Coolant pump |
| q | Removing and fitting → Chapter |
| 15 - | Crankshaft sprocket |
| 16 - | 120 Nm +90° (1/4 turn) |
| q | Replace. |
| q | Use retention tool -3415- to loosen and tighten |
| q | Do not additionally oil or grease the threads and shoulder |
| q | Tightening can be done in several stages |
| 17 - | 15 Nm |
| 18 - | Notched belt guard - lower part |
| 19 - | Pulley / damper |
| q | Can only be installed in one position: the holes are not symmetrical |
| 20 - | 10 Nm +90° (1/4 turn) |
| 21 - | Cover |
| 22 - | Notched belt |
| q | Mark direction of rotation before removing |
| q | Check for wear |
| q | Do not bend the belt |
| q | Removing and fitting → Chapter |
| 23 - | 40 Nm + 1/2 turn. (180 °). |
| q | Replace. |
| 24 - | Notched belt guard - centre part |
| 25 - | Engine support |
