Leon Mk2
| Oil filter bracket with oil cooler - exploded view |
| 1 - | Seal bolt -25 Nm |
| 2 - | Gasket |
| q | Replace. |
| 3 - | Oil cooler |
| q | Note the identification → Anchor |
| q | Coolant hose schematic diagram → Chapter |
| 4 - | Gasket |
| q | Replace. |
| q | Installation position → Fig. |
| 5 - | 15 Nm + 90° (1/4 turn) |
| q | Replace. |
| q | Tighten diagonally |
| 6 - | Gasket |
| q | Replace. |
| 7 - | Oil filter bracket |
| q | With oil check valve |
| q | The oil check valve cannot be replaced separately |
| 8 - | Oil seal |
| q | Replace. |
| 9 - | Oil pressure switch -F1-, 20 Nm |
| q | 0.7 bar - brown |
| q | check → Chapter |
| 10 - | Trim cap, -25 Nm |
| 11 - | O-ring |
| q | Replace. |
| 12 - | Oil filter cartridge |
| q | Loosen from fastener → Item |
| q | When replacing the oil filter, replace the O-rings → Item and → Item |
| q | Note fitting position: |
| 13 - | O-ring |
| q | Replace. |
| 14 - | Oil supply pipe, 22 Nm |
| q | to turbocharger |
| 15 - | Joint mouth |
| 16 - | Oil seal |
| q | Replace. |
|
|
