seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gas recirculation system > < Exhaust gas temperature sender 2, bank 1 G448 : Removing and installing

Leon Mk2

Temperature sensor behind particle filterG527: Removing and installing
Temperature sensor behind particle filter -G527-: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor
t  Tightening torques → Anchor
   
Removing
–  Detach the outer -1- and inner -2- engine covers by pulling them evenly upwards.
  E10-10038
–  Release the fuel and coolant hoses from their fittings on the air duct.
–  Remove bolt -1-.
–  Remove air duct by lifting retaining clips -arrows- slightly.
  A10-10266
–  Separate the connector -2- of the temperature sensor after particle filter -G527- and move the cables to one side.
  A23-10003
–  Remove the centre sound proofing → Exterior body installation work; Rep. Gr.50.
  A10-1565
–  Loosen the exhaust temperature sensor after particle filter -G527--1-,behind the particle filter.
Installing
Continue the installation in the reverse order of removal sequence, observing the following:
  Note
Fit the cable clamps in the same position as they were.
Fit the supercharger air system hoses and observe the assembly instructions → Chapter
Tightening torques
  A26-10189
ComponentNm
Temperature sensor after particle filter -G527- to particle filter.45
Right air hose to bracket8

   

Exhaust gas recirculation system > < Exhaust gas temperature sender 2, bank 1 G448 : Removing and installing