seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust system > < Lambda probe G39 : Removing and installing

Leon Mk2

Exhaust gas pressure sensor 1G450: Removing and installing
Exhaust gas pressure sensor 1 -G450-: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor
   
Removing
–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.
  E10-10038
–  Unplug the electrical connector -arrow-.
–  Remove the pressure sensor from the bracket.
–  Mark the hoses so as not to confuse them when installing again exhaust gas pressure sensor 1 -G450-.
–  Open the hose clamps and lubricate both hose with a non-silicone based lubricant.
–  Carefully and in a straight line ,separate the hoses from the connecting sleeves (the sleeves break easily).
Installing
Fit in reverse order from removal, remembering the following:
  Note
Secure all hose connections with the correct hose clips (original parts) → ETKA (Electronic parts catalogue).
Tightening torque
  A26-10188
ComponentNm
Pressure sensor 1 of exhaust gases -G450- to support8

   

Exhaust system > < Lambda probe G39 : Removing and installing