seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tightening torques > < Removing

Leon Mk2

Fitting
Fitting
For fitting, the operations are carried out in reverse order, taking the following into account:
–  Ensure that the sockets for centring of the engine assembly are in place on the engine block and, if not then fit them.
   
–  Position the intermediate plate in the airtight seal and fit it in the adjustment sockets -arrows-.
–  Verify, if necessary the centring of the clutch converter drive plate.
–  Check clutch release bearing for wear, replace if necessary.
–  Lightly grease clutch release bearing, release bearing guide sleeve and input shaft teeth.
–  When placing the drive train, take into account that there is sufficient play with respect to the articulated semi axles.
  A10-0129
–  When placing the engine supports, ensure that the flange of the back right console and the rebate of the front console fit into the metal/rubber bearing guide -arrows-.
–  Align the engine using a shaking movement so that the supports are not under any tension.
–  Position the bolts that attach the engine assembly to the gearbox and engine supports.
–  Remove the attachment tool -T20127- and the workshop crane.
–  Put the front exhaust tube on the exhaust manifold → Chapter.
–  Position the articulated semi axles: → Rep. Gr.40.
Vehicles with air conditioning
–  Position the air conditioning air compressor: → Rep. Gr.87.
Follow the additional instructions and assembly work → Chapter.
Continued for all vehicles
–  Position the power steering pump: → Rep. Gr.48.
–  Position the gear stick: → Rep. Gr.34.
–  Position the clutch cable: → Rep. Gr.30.
–  Position the lock carrier plate: → Rep. Gr.50.
–  If necessary, adjust the clutch cable: → Rep. Gr.30.
–  Charging the liquid refrigerant → Chapter.
–  Position the accelerator cable on the injection pump → Chapter.
–  Connect the fuel supply and return tubes to the injection pump: → Rep. Gr.23.
–  Make the electrical connections and position the cable laying: → Current flow diagrams, Electrical fault finding and Fitting locations.
–  Carry out a test drive and interrogate fault memory: → Rep. Gr.01.
  V10-1229

Tightening torques > < Removing