Leon Mk2
| Cooling system, bodywork side: disassembly and assembly |
| 1 - | Radiator |
| q | Removing and fitting → Chapter |
| q | After replacing, renew all coolant |
| 2 - | Trapezoidal drive belt |
| q | Depending on different versions |
| 3 - | Ventilator ring |
| q | Note the fitting position |
| q | This is attached to the lock carrier plate by clips → Item |
| 4 - | Ventilator for coolant -V7- |
| 5 - | Additional fan |
| q | Depending on different versions |
| 6 - | Lock carrier plate |
| 7 - | Upper flexible tube |
| q | To the liquid coolant distributor |
| 8 - | Interior flexible tubing |
| q | To the liquid coolant pump |
| 9 - | 10 Nm |
| 10 - | Connector |
| 11 - | Protection |
| 12 - | Expansion tank |
| q | Verification of the coolant system airtight seal → Chapter |
| 13 - | To liquid coolant tube |
| q | → Item |
| 14 - | To the junction hose |
| q | → Item |
| 15 - | Expansion tank cap |
| q | Test pressure 1.4 … 1.6 bar |
| q | Verification → Chapter |
| 16 - | Thermal switch -F18-, 35 Nm |
| q | For the electric ventilator |
| q | Switching temperatures |
| – | Speed 1 connection: 92 … 97 °C and disconnection: 84 … 91 °C |
| – | Speed 2 connection: 99 … 105 °C and disconnection: 91 … 98 °C |
