| –
| Separate all of the glow plugs using the -U-40082- glow plug socket spanner. |
| –
| Expel the turbulence chamber by tapping through the injector placement using a hammer. |
| –
| Remove the combustion residue from the contact surfaces of the cylinder head turbulence chamber. |
| –
| Fit a new turbulence chamber; the assembly position will be determined by the groove and the guide tab. |
| –
| Insert the turbulence chamber by using a plastic mass. |
| –
| Measure the protrusion of the turbulence chamber: Theoretical value: 0.07 mm maximum |
| If the specification is exceeded: |
|
|
|
