seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Check the slide travel sender G149 > < Check conditions

Leon Mk2

Checking process
Checking process
–  Connect fault reader -V.A.G 1551- (-V.A.G 1552-). Start engine and select “Address code” 01 to select engine control unit.
   
Indicated on display:
–  Press keys 0 and 8 for the function “Read measured value block” and confirm entry with Q key.
  
Rapid data transfer                 HELP
Select function XX
Indicated on display:
–  Press keys 0, 0 and 1 for “Display group number 1” and confirm entry with Q key.
  
Read measured value block               
Enter number group values XXX
Indicated on display:
–  Check coolant temperature in the display field 4. Specification: 85 °C min.
Do not continue with the check until the coolant temperature has been reached.
  
Read measured value block      1       →
900/min   6.5 mg/H    1,680 V    87.3 °C
– 
–  Check display in display field 3 ( slide travel sender voltage). Specification: 1.500...2.100 V
–  Press → key.
–  Press keys 0 and 6 for the “End output” function and confirm input with the Q key.
–  Switch off ignition.
–  If the specification is not reached, check the slide travel sender and dosifier as follows:
  
Read measured value block      1       →
900/min   6.5 mg/H    1,680 V    87.3 °C

Check the slide travel sender G149 > < Check conditions