seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure and oil pressure switch: testing > < Oil pump: removing and installing|Remove

Leon Mk2

Installation
Installation
Condition
   
l  A part of the drive cams -arrow- is at the upper part of the crankshaft.
Work sequence
–  Fit the new gasket on the guide pins.
–  Oil the drive cams of the crankshaft.
  N17-0081
–  Make the arrow -A- on the inner rotor of the oil pump coincide with the installation position mark -B- on the oil pump housing cover.
–  Lightly oil the sealing side of the oil pump seal.
  N17-0074
–  Fit guide sleeve -T20081/2- on the oil pump seal and carefully guide the pump onto the drive cams of the crankshaft.
–  Align the inner rotor if necessary, staggering slightly with respect to the drive cam on the crankshaft.
–  Then carefully fit the oil pump on the guide pins.
–  Install the oil pump.
–  Remove guide sleeve -T20081/2-.
–  Install the air intake line → Item.
–  Install the oil sump → Chapter.
–  Install the support vane pump-compressor-alternator; follow the tightening order → Item.
–  Install the toothed belt pinion and the tensioning roller, Toothed belt, install, tighten → Chapter.
  E17-0007

Oil pressure and oil pressure switch: testing > < Oil pump: removing and installing|Remove